Re: how to install tear?
 

Yeah, I checked this thread before fully reading the Tear 0.3.1 thread and I tried this first.

@badog, like me, I suggest fully reading the "installation instructions" on the Tear 0.3.1 thread. I didn't do that and wasted a good 5 minutes because I didn't bother to read part about Qole's moved repository.

Jesse~

Re: how to install tear?
 

/home/user # apt-get install libidn11 libxslt1.1 libpcre3
Reading package lists... Done
Building dependency tree
Reading state information... Done
The following NEW packages will be installed:
libidn11 libpcre3 libxslt1.1
0 upgraded, 3 newly installed, 0 to remove and 45 not upgraded.
Need to get 490kB of archives.
After unpacking 1114kB of additional disk space will be used.
WARNING: The following packages cannot be authenticated!
libpcre3 libidn11 libxslt1.1
Install these packages without verification [y/N]? y
0% [Connecting to repository.maemo.org (124.40.42.64)]


then stop...

Re: how to install tear?
 

Also, according to this, once you enable Qole's repository you ONLY need to install Tear. No need for a separate libwebkit install.

Also, Ray said "Still some clicks away from a user-friendly "One-click install"". That's b/c there are bugs. However, I am still thrilled with Tear.

Re: how to install tear?
 

See also this:
http://wiki.maemo.org/Tear#Installing_Tear