![]() |
Re: FM radio transmitter idea
Quote:
|
Re: FM radio transmitter idea
You should start fmboost AFTER starting fm transmitter. If you plug or unplug cables, start or stop fm transmitter, the boost is undone.
|
Re: FM radio transmitter idea
shadowjk, fmboost is now integrated in Simple fmtx desktop widget, you must only configure the widget to use it.
|
Re: FM radio transmitter idea
I thought I'd dig this one out because I'm about to take a motorway/freeway trip tomorrow and have to take the car which doesn't have an aux input on the radio, so that means using the N900 FM transmitter. Being a long trip, this will invariably mean changing frequencies on both the N900 and radio from time to time to keep the frequency clear. This wouldn't be so bad if I could convince the wife to drive, but it'll be me driving as usual, so I won't be able to keep fiddling with the frequencies without pulling over every dozen miles or so.
The original poster was onto a good thing with this and it was working out, but the thread kind of fizzled out when discussing using fmboost. There is still a good case for developing a program to scan for clear frequencies. This could either be used to build a map of clear frequencies on specific frequently travelled routes (motorway networks perhaps), or as was suggested, perhaps to use RDS to enable the FM transmitter to renegotiate the 'station frequency' on the fly. I presume that the N900 is not capable of transmitting and receiving simultaneously, anyone know this? Changes of designated frequency could be triggered by GPS location if a community created 'clear frequency map' was developed from the pooled N900 users frequency scans. The resultant frequency map might be used as the basis for the development of similar applications on other platforms, a bit like those dynamic speed camera databases. It's all too complicated for me to even contemplate, but it would be dead neat if it could be made to work. |
Re: FM radio transmitter idea
Here is something everyone can do to get trouble free transmission from your N900 to car radio.
Either unscrew the whip or push down the antenna (depending on the type of radio antenna fitted) or try the following... what is needed is a simple switch to disconnect the antenna wire from your radio, the centre wire in the coax of your antenna lead going to the actual antenna on your car, what this will in fact do is stop the antenna from working and will give you a quiet radio that will pick up the local transmission from your N900 as it will be in the car without any interference from an outside broadcast. Worth a try. |
Re: FM radio transmitter idea
Quote:
personally i get a fantastic signal all the time on 1 frequency, keeping my n900 in the cubby-hole directly below my stereo. |
Re: FM radio transmitter idea
Yep good idea that as all you need to do is null the signal from the antenna stop it from getting to the radio.
Incidently you can buy an antenna switch, switch out the external antenna is all thats needed. |
Re: FM radio transmitter idea
The fm transmitter chip actually has the capability to scan for least noisy channels and transmit there.. I don't think the kernel driver supports it though. I don't know if it can send and scan at same time.
|
All times are GMT. The time now is 23:36. |
vBulletin® Version 3.8.8