![]() |
Re: Sensitivity of touch screen
Quote:
|
Re: Sensitivity of touch screen
ok
last week with the onedotzero stuff. there was a LOT of hands on time with the device. and i am pleased to say its really really responsive. however a lot of people were still trying to be gentle and not break the screen so at first were doing feather like presses and swipes. i watched them try it and it didn't always respond so they would just do it again a bit harder - it was like finding the biting point of your car clutch. once they knew the level they were happy to use finger to navigate around and touch/swipe worked perfectly. its MUCH better than n810 and its entirely possible now to do scrolling and selection with finger pads :) |
Re: Sensitivity of touch screen
Quote:
|
Re: Sensitivity of touch screen
I equate capacitive to a paint brush. It activates on contact. Resistive is like a crayon. You have to press, but only lightly, like using a pencil. The amount of touch required is very little, and like he said, once you use it 2 or 3 seconds, and realize it works off of detecting the pressure, not the contact, and you get it.
|
Re: Sensitivity of touch screen
The screen is really sensitive but at times it takes a gesture to activate some parts, ie if your on the home screen, you have to start swiping from the middle to the edge to change desktops. But then in the repo, the smallest swipe downwards would start the list kinetically scrolling. (really nice btw)
So i think its built into the firmware that you have to make certain gestures in order to avoid accidental activation. I like this process on the whole, with the iphone im constantly activating things by mistake with the lightest touch. . |
Re: Sensitivity of touch screen
Quote:
At least it has a proximity sensor so it shouldn't take much code to make it do this if it doesn't out of the box. |
Re: Sensitivity of touch screen
Quote:
The input from proximity sensor alone is not adequate to determine the device's location (is the proximity sensor covered because it's inside the pocket or covered by the user's palm/fingers due to certain app's handling requirements?). And there's also the issue of the screen being prone to misclick during the motion to 'holster' or take it out, as mentioned in previous post. |
Re: Sensitivity of touch screen
Look at autolock on the N810. Uses the light sensor to detect if it is in the sleeve. Works almost perfectly, almost never mistakes your hand for the sleeve or something like that.
|
Re: Sensitivity of touch screen
IIRC the N900 has a light sensor as well. Porting autolock shouldn't be a big problem if the D-Bus interface didn't change too much.
|
Re: Sensitivity of touch screen
Quote:
Quote:
Excellent! I'll be sure to look that up when I get my N900. Thanks. |
All times are GMT. The time now is 07:58. |
vBulletin® Version 3.8.8