Re: Re Flashed N900 - Yay - But Help
 

you may have to flash it a few times though some people said it doesnt flash it all one go, but try it one time check if it worked then if not do it again

Re: Re Flashed N900 - Yay - But Help
 

No mention of:?
If not backup MyDocs and reflash the eMMC

Edit: You have to flash the fiasco image again, then the eMMC
Remove the -R option when flashing the FIASCO image.
http://wiki.maemo.org/Updating_the_f...MC_in_the_N900

Re: Re Flashed N900 - Yay - But Help
 

ok, it says never boot the device before installing the emmc, yet you have to do the firmware first, which aito reboots anyway. Is it safe to flash the emms after its' rebooted?

Re: Re Flashed N900 - Yay - But Help
 

No, read the wiki again.
"Flash the FIASCO/rootfs image first using the above commands, WTIHOUT the -R at the end of the command. "
DO NOT add -R when reflashing the fiasco image.

Re: Re Flashed N900 - Yay - But Help
 

Ok, tried omitting the -R, but it did nothing

Re: Re Flashed N900 - Yay - But Help
 

Tried the vanilla with the above command. It says error code 1 and back to pro mpt the N900 hangs

Re: Re Flashed N900 - Yay - But Help
 

It will flash without rebooting, you then have to reflash the eMMC :/

Re: Re Flashed N900 - Yay - But Help
 

Ok. This what I have done. Flashed the device with latest firmware (UK). Success (Omitted the -R)

I then entered the flasher-3.5.exe -F RX-51_2009SE_1.2009.41-1.VANILLA_PR_EMMC_MR0_ARM.bin -f -R

And the system asked for USB connection, then went through code, the N900 showed the 4 white dots, cycled through them and hung.
The terminal in XP showed error 1 code.

Am I doing it correct?

Re: Re Flashed N900 - Yay - But Help
 

It then find the USB, then boots the device in flash mode
and then:-
SU_GET_UPDATE_STATUS_REQ terminated with error code 1

the N900 hangs on the white dots

Re: Re Flashed N900 - Yay - But Help
 

Done it both a success.
But Still 70 MB memeory