Re: [WIP] Jolla OtherHalf OLED display
 

Just received mine, but... Where is the software?

Re: [WIP] Jolla OtherHalf OLED display
 

> Just attach the toholed to phone, and it will install automaticallly.
>
> If you habe tohd disabled due the early battery drain issues, you need to re-enable it.

Re: [WIP] Jolla OtherHalf OLED display
 

[root@Jolla nemo]# systemctl status tohd.service
tohd.service - The Other Half Daemon (TOHD)
Loaded: loaded (/lib/systemd/system/tohd.service; disabled)
Active: active (running) since Fri 2014-08-08 16:16:57 CEST; 2min 16s ago
Main PID: 2727 (tohd)
CGroup: /system.slice/tohd.service
└─2727 /usr/sbin/tohd

Aug 08 16:16:57 Jolla systemd[1]: Started The Other Half Daemon (TOHD).
Aug 08 16:17:24 Jolla tohd[2727]: timeout; terminating discovery
Aug 08 16:18:28 Jolla systemd[1]: Started The Other Half Daemon (TOHD).
Aug 08 16:18:58 Jolla tohd[2727]: timeout; terminating discovery

Re: [WIP] Jolla OtherHalf OLED display
 

hmm. insert to upper edge first, and finally the bottom right corner so the microswitch is pressed last.

does your standard jolla toh work?
do you hear the sound?
do you see tohid in about device page?

Re: [WIP] Jolla OtherHalf OLED display
 

No, any TOH plug does nothing and timeouts the daemon.

Re: [WIP] Jolla OtherHalf OLED display
 

uh, duplicate.debugging :)

then first try to get the jolla toh working properly.
there was similar issues with one other, i'll check irc backlogs when i get back to home.

Re: [WIP] Jolla OtherHalf OLED display
 

Ok, thank you :)

Re: [WIP] Jolla OtherHalf OLED display
 

those issues were fixed by rebooting and retrying.
propably NFC is not read properly.

trying to install toh like i described, bend it a little so that nfc id is close (pressed against) phone, and then snap the rest of it in place.

Re: [WIP] Jolla OtherHalf OLED display
 

nothing happens. I tried it a lot of times. The First One OH is not working :(

Re: [WIP] Jolla OtherHalf OLED display
 

Can you check that the toh-event is given when you insert/remove toh

cat /proc/interrupts | grep toh

That number should increase