Re: Jolla OtherHalf OLED display / toholed
 

This batch almost complete.
Shipping hopefully on wednesday 10.12.

https://pbs.twimg.com/media/B4XQMq3CIAEeTkD.jpg:large

Re: Jolla OtherHalf OLED display / toholed
 

While updating I was getting error messages from the store. So I thought I'll try unsinstalling and then reinstalling from the store.

But now the phone doesn't seem to recognize my TOHOLED at all. I doesn't ask permission for install and the screen is dead. Any way to fix this?

Re: Jolla OtherHalf OLED display / toholed
 

something wrong with NFC detection?
dbus-monitor --system | grep TOHID
and attach toholed.

Re: Jolla OtherHalf OLED display / toholed
 

Same here: something wrong with NFC detection apparently as we discussed by email. Toholed works though, after the manual installation.

NFC is working with my The First One OH.

Sometimes toholed stops working and I suspect a bad contact somewhere, I can restart it easily by running systemctl restart harbour-toholed.service as root.

Re: Jolla OtherHalf OLED display / toholed
 

Please check also which revision you have, on top right corner inside toh,
if it says REV5 and you have problems, i can replace it for cost of stamps.

The EEPROM read algorithm will be improved in u10, which makes it easier to attach toholed. (now if the electrical contact is not good when microswitch is pressed, it will not start daemon)

Re: Jolla OtherHalf OLED display / toholed
 

Toholed V1.00, serial number 003, March 26th 2014. http://forum-images.hardware.fr/icones/redface.gif

By the way, do you have a rough ETA for the final design that you would ship at some point (no worries, just asking, I'm not impatient at all, my toholed already works).

Re: Jolla OtherHalf OLED display / toholed
 

Kabouik: As you have the really old prototype, PLA printed black, IIRC it does not have dimple to press microswitch. That's why it does not start automatically :p

Re: Jolla OtherHalf OLED display / toholed
 

Now that finally explains why I was very dubious when Dirk told me the material was the same for my toholed and my diptoh/tohkbd1. :)

The PLA material was good, smooth and strong (permanent) colour, though a bit prone to deformations when overheating.

Re: Jolla OtherHalf OLED display / toholed
 

Problem solved. EDIT: it just strangly started working all of sudden. Don't know why.

Kaikkea mahdollista koitin ja mikään ei toiminut. Sitten avasin noin miljoonannen kerran kuoren tarkistaakseni tuon revikkanumeron, jonka mainitsit. Just silloin Jolla päätti puoliskon tunnistaa, asensi ohjelmat ja nyt kaikki pelittää ihan OK.


:)

Re: Jolla OtherHalf OLED display / toholed
 

Software moves in mysterious ways