Re: Multiboot Kernel Power issue
 

Try to boot into Maemo default kernel and reinstall kernel-power-bootimg. This should not touch multiboot setup.

Re: Multiboot Kernel Power issue
 

The moment i start the phone it enters the Uboot. i am not able to access Multiboot option.
1) keeping the keyboard close it stucks at Starting Kernel ...
2) keeping the Keyboard open boots the phone in Meego
3) Keeping the keyboard open and interupting the Autoboot and than trying to load power kernel using "RUN NOLOBOOT" it stucks at starting Kernel ...
4) keeping the keyboard close and opening it immediately after it shows " Loading Kernel Image ... OK" ( as informed by fabry in his TRI-BOOT thread) again stuck at starting kernel ...

Re: Multiboot Kernel Power issue
 

Probably you have an N900 with HW revision greater than 2101.

My U-Boot is based on Matan's u-boot and this version, as told many times, has problems (i.e. hangs on starting kernel) with phones different from hw rev 2101

You can remove u-boot from your phone by flashing a normal (aka without u-boot) kernel, and only the kernel, with flasher-3.5 tool.

There are many guides which can show you the correct steps to follow

Re: Multiboot Kernel Power issue
 

Yes if your phone is a rev 2101 keep on use my version until Pali will fix problems on his release.

Re: Multiboot Kernel Power issue
 

Yes My HW is 2204. i'll be flashing my device with Kernel only using the PR1.3 file

EDIT: I successfully flashed my phone and am back with NITDORID intact. I took time since i am using a Vista 64bit and the below option was the only option that worked.

Now will wait for the Pali's Uboot version to have TRI-BOOT on my phone.

http://talk.maemo.org/showpost.php?p...0&postcount=20

Re: Multiboot Kernel Power issue
 

Newer release of Pali's U-Boot published.

Unfortunately changelog not reports yet fixes for two known problems:

• High power consumption
• Incompatibility with HW Rev different from 2101 (as Matan's version)

Re: Multiboot Kernel Power issue
 

Hardluck for guys like me using HW 2204 will wait for the further release supporting other HW's

Re: Multiboot Kernel Power issue
 

Pali tells that his latest version now supports hw 2204.
I have 2101 and I can't confirm this information, you should try yourself

But I can tell you that power consumption problem is present yet.
So it is usable only for 8-10 hours without recharge

Re: Multiboot Kernel Power issue
 

Hi to all.I am with kp49.After install multiboot i can't see the titan kernel,i try reinstall mltiboot,but no result.Then i remove multiboot and kernel-power-bootimg,and again installed them(bootimg and multiboot)but result was the same.I can't use this:
because i no have "00-Maemo-2.6.28-omap1.item'' in that directory /etc/multiboot.d/.I try to copy from /lib/modules/omap1 to /etc/multiboot.d/,but again without success,i try also copy with winscp from /lib/modules/omap1 to /boot/ and /etc/multiboot.d/,again failed.Then i try with winscp to copy from /etc/multiboot.d/examples/omap1 to /boot/ but result it was i lose multiboot,of course i remove both(bootimg,multiboot) and solved problem,but is there any option when someone install mutiboot with kp49 to see both kernels(titan and kernel-power)