Re: [Announce] QNetMan
 

Updated to 0.6.4 using ur .deb, no problems whatsoever.

Ideas: perhaps you could display network and broadcast addresses, though I'm not sure how useful it would be since most people who would need it could calculate it anyway.

Could you add tun/tap interface as well?

N00b question: what is the ppp0 interface used for? IPsec? I know what the ppp stands for, but if some1 could give me a few examples for use would be appriciated.

@Reflektorfalke: can I ask you which version you had previously installed and also wether you use any script to move-symlink files from /opt ?
Which version are you using now?
Which version are u using now?
Did you try reverting to the older version?

"Yes, had older version an it worked until recently." Does this mean it stopped working before you updated?

Re: [Announce] QNetMan
 

Now I'm working on so that the user himself can add any network interface.

ppp0 :
After I added it, I began to think, and if found ppp0 on the Nokia N900 :D
ppp - network interface protocol for point-to-point.
For example, GPRS connections using this protocol, but there is a network interface named as gprs0

@Reflektorfalke: You can try to install version 0.6.5 ?

Re: [Announce] QNetMan
 

hi , tried this for the 1st time yesterday , installed v0.64 , widget worked fine but app wouldnt open at all, would start loading then close.
updated to v0.65 this morning. widget still ok and app now opens but crashes when i click anything except "about" and again crashes after about 10 seconds if no button is pressed...

Re: [Announce] QNetMan
 

Please tell me you have installed CSSU ???

Re: [Announce] QNetMan
 

yes . latest cssu installed

Re: [Announce] QNetMan
 

I also got CSSU, it doesn't interfere. (though I don't have devel enabled only testing)

Re: [Announce] QNetMan
 

CSSU installed on my N900, QNetMan works without problems
On my SDK such problems is also not observed.
I asked my friends, too, such problems have no
:confused:

Re: [Announce] QNetMan
 

I upgraded to latest version, now I get the same result as described by moepda (with previous version it didn´t get further than startup screen). App closes when tapping a button or after waiting ~10 sec due to a segmentation fault...

I also downgraded to v0.4.5-1 (after purging current version).
Again fails with seg fault.
As I unfortunately cannot says which version was the last working one, I wanted to try older versions but they are all cleaned by repository management, so I can´t download them anymore...

Yes, I once tried a command in xTerm to move files from /opt using symlink

Re: [Announce] QNetMan
 

you can download any version of the home page

Сheck, may be in the directory /opt/qnetman have any file after the package was removed. On a good should not remain even the catalog.

Tomorrow I'll make the package is not on the library pyside, and will use the library PyQt4. If you have time, please check the package .. Link to the package I will give
Thanks for your help.

Re: [Announce] QNetMan
 

Well, now I played the "install - purge - install - purge - ..." game from v 0.1.1 till 0.5.8 with no success, each one failed with seg faults :confused:

Sure will try the PyQT4 based package tomorrow.
If I can do anything else to debug this, let me know...