Flashing the eMMC first?
 

question , do we need to Flashing the eMMC first or flashing the firmware first?


so this is what i did .it didnt do anything, when i click enter it comes out the flasher 3.5 exe run admin, then i click it , the CMD wont running.

Re: Flashing the eMMC first?
 

I always flash FW first

Re: Flashing the eMMC first?
 

i see, hey,,when i click run as admin on the flasher-3.5 it it show up in .5 second then command prompt dissapeaar..how is that? something wrong or , how do u do it? my pc is visita 32 bit

Re: Flashing the eMMC first?
 

you have to do everything in CMD ... the flasher doesn't run like a normal program

i used this guide it was very helpful :

http://discussions.europe.nokia.com/...ata/m-p/591877

Re: Flashing the eMMC first?
 

flash emmc first. flashing fw first then emmc is pointless because you'll end up flashing fw twice.

Re: Flashing the eMMC first?
 

i just did it, i use CMD type everything in there, it still didnt flash ?

Re: Flashing the eMMC first?
 

if you want completely new fresh out of factory unit then flash emmc first then put on new firmware. if you flash firmware first, all your data and settings still there. pointless

Re: Flashing the eMMC first?
 

what does it say?

EDIT: that file name is a little short ... did you rename it?

Re: Flashing the eMMC first?
 

the code/command you have written is really wrong mate this is why it wont work , command prompt needs to be told what to do and you have told it jibberish and thefore it hasnt worked

the command should be like this

flasher-3.5.exe -F RX-51_2009SE_1.2009.41-1.VANILLA_PR_EMMC_MR0_ARM.bin -f -R

if your emc file is called RX-51_2009SE_1.2009.41-1.VANILLA_PR_EMMC_MR0_ARM.bin

then youll write the above into command prompt to get it to work

Re: Flashing the eMMC first?
 

When u flash emmc the firmware version does not reset.

Re: Flashing the eMMC first?
 

yea, i did renamed it , as RX_002-bin。 then it did not work on command prompt. the flasher 3.5 didnt work.

Re: Flashing the eMMC first?
 

Click Start > All Programs > Maemo > Maemo Flasher > Maemo Flasher 3.5, right click it, start as administrator.
Type the command and use tab to complete the filename, the error that's closing the flasher should show up now

Re: Flashing the eMMC first?
 

thank you very much ,it's working now.:D