![]() |
N950 - Device not working properly
Hello, battery in my N950 was for 3 years dead and I finally brought a new original Nokia BL-4D. I put it into my N950, it light up but showed me only error message that Device not working properly and that I should contact Nokia Care. There is _no_ security error message which was visible after messing aegis. Note that device worked fine 3 or 4 years ago with previous battery. It had official PR 1.2 release. Is there any way to make N950 working again? I have tried to enable R&D mode and disabling lifeguard reset but it had no effect.
|
Re: N950 - Device not working properly
Probably reflashing would help... but after messing with mine N950 after simple flashing and breaking it, I would be very careful.
|
Re: N950 - Device not working properly
Yea, I do not want to try refleshing because n9/n950 can be easily more broken...
Anyway this is the current state: Code:
$ 0xFFFF -I |
Re: N950 - Device not working properly
Here the 0xFFFF output of a working N950 PR1.3 as comparison.
Started 0xFFFF and connected then the phone in off state with usb (with original Nokia cable short version CA-101D). Code:
0xFFFF v0.10 // Open Free Fiasco Firmware Flasher |
All times are GMT. The time now is 12:13. |
vBulletin® Version 3.8.8