Problem with 5 PR1.1 Update
 

I've just download the update. After the download had completed my N900 rebooted and I get this message :
Code:

Installing software update.
Please do not interrupt.

After 1min it reboots again, and I get the same screen again.
I can't connect to my pc to back it up (windows 7 32bit).
Can someone help?

*http://talk.maemo.org/showpost.php?p...&postcount=140

Re: Problem with 5 PR1.1 Update
 

Did you not read my response to this in the other thread?

Re: Problem with 5 PR1.1 Update
 

Yeap, but I wanted to hear the opinion and suggestions from other ppl too. If this is bad delete the post, or report it.

Re: Problem with 5 PR1.1 Update
 

What other suggestions are you looking for? Currently you have a linear problem with only one solution. That is making it stop rebooting over and over.

There is only one solution to that. Remove the battery. Don't turn it back on. The N900 behaves differently if you boot it up while attached to a USB cable then it does without it.

So take the battery out. Put it back in. Leave it off. Attach it to your PC via USB, then power it on again. Also the firmware updating software works in the same method.

Re: Problem with 5 PR1.1 Update
 

I plugged the battery out. Plugged it back in. Plugged USB cable. Then it automatically switched on and did the same.

And it keeps rebooting.

Re: Problem with 5 PR1.1 Update
 

So it turns itself on after you put the battery back in?

Is the hardware button on top jammed somehow? That shouldn't happen.

Re: Problem with 5 PR1.1 Update
 

Nope, it works good. When I attach the USB cable it automatically turns on.

Now, I've pulled the battery off. Plugged the USB cable, and it didn't turned on by itself.

Re: Problem with 5 PR1.1 Update
 

I have the same problem...there's a solution??? :(

Re: Problem with 5 PR1.1 Update
 

after the update i still cant use # commands :(
help plz.

Re: Problem with 5 PR1.1 Update
 

i meant USSD commands like *100# to check balance on prepay connection.