![]() |
Cant' flash N900: Returns %m
Title says it all.
Ever since I switched over to AT&T I have been having some very strange issues with my device (read: ever since a customer service rep. suddenly pulled the battery out while it was running) 1. The N900 has been rebooting with the following message on restart: unexpected reboot, your kernel settings were not saved 2. There have been sudden changes in all titles (everything has a bunch of letters and numbers before things as simple as yes and no buttons). 3. I am also asked to allow roaming to connect to the network internet (otherwise I cannot connect) even though I am fully within the coverage area. Even then the connection keeps getting disconnected. 4. X-terminal returns no errors. So I decided to attempt a flash ( renamed firmware and eMMC as RX-51.bin and R.bin respectively) However, when I run : flasher-3.5.exe -F R.bin -f -R I receive: R.bin: %m Any thoughts? |
Re: Cant' flash N900: Returns %m
Try to flash the kernel only? I'm not an expert, but this section of the wiki might help you:
http://wiki.maemo.org/Updating_the_t...a_FIASCO_image Also, I'd punch the customer service rep. |
Re: Cant' flash N900: Returns %m
Quote:
If it is windows, you are expected to type Code:
flasher-3.5.exe -F C:\XXX\XXX\R.bin -f -R Code:
C:\Program Files\Maemo\Flasher3.5\ Also If you are trying to flash the eMMC, do make sure you have Nokia PC Suite and Follow the guide as stated by RiD in the above post. These instructions are for Windows.... |
Re: Cant' flash N900: Returns %m
if the eMMC is R.bin then why are you appending -R to the command!?
|
Re: Cant' flash N900: Returns %m
in my case %m showed up when i typed the image name wrong, or didn't even have the image file in the folder
|
Re: Cant' flash N900: Returns %m
The most easiest way is to. Drag the file to the maemo flasher window. It will automatically register its location. And click enter.
|
Re: Cant' flash N900: Returns %m
I didn't mean to ad the -R when posting :o
I've been running through everything and have the flasher recognizing the commands at this point. However, it will not recognize the device. I have found the workaround for windows 7 (Current OS) and still nothing. I get the dim Nokia screen with the USB and the flasher keeps looking for a suitable device. I have never had this many problems flashing before:mad: |
Re: Cant' flash N900: Returns %m
Just use unetbootin with a flash drive and hopefully that way it should remove a lot a variables like bad drivers or something in windows interfering with the process.
|
Re: Cant' flash N900: Returns %m
Quote:
|
Re: Cant' flash N900: Returns %m
Quote:
Alternatively Try the following if using a 32bit OS. 1. Turn Off your N900 completely. (Also no USB Cable attached at this point) 2.Make sure you have Nokia PC Suite or OVI PC Suite installed. (Nokia Connectivity Drivers is needed for eMMC Flashing) 3. Run the flasher command (FIASCO Image to be flashed first) 4. Now connect the cable to the N900 and keep U pressed. 5. The flashing should begin without any hassle.. May take not more than 10 seconds to start. 6. Run the flasher command (eMMC Image to be flashed last) Note: Do not use -R while flashing FIASCO Image |
All times are GMT. The time now is 23:08. |
vBulletin® Version 3.8.8