![]() |
N900 Touch Screen Has Stopped Responding To "touches"
So here is a bulleted chain of events prior to my touch screen failing to respond.
Here is what does work:
This is what I've tried. I've tried to re flashing using instructions on http://wiki.maemo.org/Updating_the_tablet_firmware without success. So I've investigated a bit and it appears there are OEM screens I can purchase and there are youtube videos that make it feasible to replace. I don't have a problem investing in a replacement but I just want other people's feedback. Any feedback is greatly appreciated. REFERENCE: http://youtu.be/pDQ81cahD1c |
Re: N900 Touch Screen Has Stopped Responding To "touches"
I guess I'm hosed on this one.
If anyone can chime in this question I'd appreciate it. Q: How can I tell whether the problem lays in the controller or the actual LCD touchscreen? I will be thankful for any feedback. :):):):):) |
Re: N900 Touch Screen Has Stopped Responding To "touches"
If you have a screen protector, just remove it. I had same problem and was thinking about software fault but problem was my screen protector.
|
Re: N900 Touch Screen Has Stopped Responding To "touches"
I did remove the screen protector but the issue is still there.
Thanks |
Re: N900 Touch Screen Has Stopped Responding To "touches"
I'm going to disassemble it and verify all PCB flex cables are visually OK. I don't have a microscope so I'll basically do this with my 20/20 vision.
|
Re: N900 Touch Screen Has Stopped Responding To "touches"
Did you expose it to the direct sunlight/high temperature (you mentioned swimming)?
|
Re: N900 Touch Screen Has Stopped Responding To "touches"
i can confirm that its not your LCD screen that cause you this problem but the digitizer...replace the digitizer then your touch screen will be ok...
for all info it is not the LCD screen that is touchables but the digitizer that give the response on every touch...if you don't know what is a digitizer then google it... |
Re: N900 Touch Screen Has Stopped Responding To "touches"
Quote:
Do you know which digitiser did Nokia used in N900? |
Re: N900 Touch Screen Has Stopped Responding To "touches"
Quote:
|
Re: N900 Touch Screen Has Stopped Responding To "touches"
Quote:
To visually inspect, dissassemble The screen assembly. I would go so far as to remove the LCD. I.E. seperate the LCD, DIgitiser and slide mechanism. I highly doubt they have been physically damaged. Leave these parts in a warm dry place over night. i.e. on top of the fridge/in airing cupboard/whatever. Re-assemble and check to see if the problem persists. If the problem persists that would imply the problem lies a little deeper. If that is the case, seal it all back up, feign ignorance and sell it on ebay with a vague clue 'the software screwed up'. Some N900 enthusiast will buy it in the hope that it only needs a reflash. word of caution, the screws on the screen assembly are SUPER lightweight, do NOT over tighten them THEY WILL STRIP! This is all assuming your phone is out of warrenty... |
All times are GMT. The time now is 06:45. |
vBulletin® Version 3.8.8