![]() |
nokia N9 won't boot
1 Attachment(s)
I had a battery drain issue and decided to follow some instructions to try to boot my device. I downloaded the right firmware and flasher and I run "flasher -f -F main.bin" so I had the battery charging. I cancelled on the 10th minute before the flashing would be able to start. Since then I get the nokia logo and the rest you will see on the photo below.
The question is, have I lost my data? had fasterN9 installed if that has anything to do with my case. |
Re: nokia N9 won't boot
I have tried several times and I have read several post and I am a bit confused. Somehow running ubiboot image I saw my files in ubuntu but I cannot copy - paste rootfs files.
I can flash my phone successfully but does not want to boot. It stays in the nokia logo. Still I haven't tried the -emmc.bin cause I want some of my data if not all. Question: if I want to save just the data of an app and do a fresh install with -emmc.bin --no-preserve and copy the data of the app, will I be able to rescue data? |
Re: nokia N9 won't boot
if you flash emmc all your data will be wiped.
in ubuntu start nautilus with root privileges to copy files |
Re: nokia N9 won't boot
Quote:
Try to use "sudo" to access them. |
Re: nokia N9 won't boot
So if I manage to copy rootfs partition and do a fresh flash in my n9 with -emmc --no-preserve and replace the rootfs partition previously copied will the data be saved?
|
Re: nokia N9 won't boot
Well it depends on what exactly is wrong with the device, if you have corrupted a file and you replace the filesystem with previous image after flashing, you will get the old problems back :D
Do you know where is the problem, is it on /root/ or /home/ partition? |
Re: nokia N9 won't boot
i think you have similar problems than i. also battery was down and the put off. after it dont charge and dont boot harmattan. since my n9 is new with new data. flash with preserve option bring back to live harmattan.
|
Re: nokia N9 won't boot
Quote:
You can just use "flasher -i" to get into charging mode, white led breathing for few hours, and then you enter "flasher -R" |
Re: nokia N9 won't boot
Quote:
|
Re: nokia N9 won't boot
I run the command
sudo flasher -f -F main.bin -F emmc.bin --erase-user-data=secure -R I had successfully flashed but still only nokia logo appears and led blinking while connected. I should guess that I have a hardware problem afterall, no? Raw data transfer EP found at EP2. Ping attempt 1 (250 ms) Server application: 1.7.2 Found product RM-696 rev. 1507 Server implements softupd protocol version 1.8 Battery level 37 %, continuing. Erasing, this may take a while. Erase done. Image SW version DFL61_HARMATTAN_40.2012.21-3_PR_005 Image moslo not present Image tar skipped Image config skipped Battery level 42 %, continuing. image [state progress transfer flash speed] --------------------------------------------------------------------- [x] cert-sw [finished 100 % 1 / 1 kB NA ] [x] cmt-2nd [finished 100 % 95 / 95 kB NA ] [x] cmt-algo [finished 100 % 789 / 789 kB NA ] [x] cmt-mcusw [finished 100 % 6050 / 6050 kB 3121 kB/s] [x] xloader [finished 100 % 23 / 23 kB NA ] [x] secondary [finished 100 % 94 / 94 kB NA ] [x] kernel [finished 100 % 2714 / 2714 kB 3185 kB/s] [x] rootfs [finished 100 % 1170162 / 1170162 kB 11198 kB/s] [x] mmc [finished 100 % 1946679 / 1946679 kB 19449 kB/s] Updating SW release Success pez@pez:~$ |
All times are GMT. The time now is 17:57. |
vBulletin® Version 3.8.8