Dead Jolla Tablet - wont turn on wont charge
 

This morning my 32GB Tablet was effectively Dead. :( ie would not turn on, would not charge.

Current charging on good quality 2 Amp charger with my N900 USB cable.

It was working fine last night, when left it was not connected to anything ie charging or connected to computer.

The battery was low, maybe very low, I dont think I had switched it off.


..any suggestions?

Re: Dead Jolla Tablet - wont turn on wont charge
 

If your battery is completely empty you are only able to wake it up with a 2 A charger - try another newer USB cable for this purpose.

It's also possible that you are experiencing the issue where the Jolla Tablet is turning off by itself - try to push the power button several times for >10sec.

Re: Dead Jolla Tablet - wont turn on wont charge
 

Thanks willi6868

I pushed the power button for several seconds as suggested and the Charging icon appeared. It showed 0% - its now showing 1%

:):):)

Re: Dead Jolla Tablet - wont turn on wont charge
 

Also i have a problem with usb connector in tablet, sometimes it shows charging, but actully not charging. need to push cable inside, or use different cable.

Re: Dead Jolla Tablet - wont turn on wont charge
 

Update - now 65% surely thats not normal to only get to 65% after approx for 6 hours charging? Boots Ok though

Re: Dead Jolla Tablet - wont turn on wont charge
 

check your charger current :)

Re: Dead Jolla Tablet - wont turn on wont charge
 

i had to push the power button round about 30 to 60 seconds until the device came back

Re: Dead Jolla Tablet - wont turn on wont charge
 

Yes, I have the same issue. Seems it developed over time.

Re: Dead Jolla Tablet - wont turn on wont charge
 

Over *very short* time that must be.

Re: Dead Jolla Tablet - wont turn on wont charge
 

Well, mine is several months, while Coderus' is even longer if I remember correctly. :) The issue manifests itself as some cables stop working so well as if the port gets a bit wider and loose. The port itself looks solidly soldered.