@Xagoln,

I installed ver0.0.4-1 and reboot as usual. There is a "Kill" pop-up message appeared on desktop. Does it stand for "Killing" of the rtcom-messaging-ui ??

I checked the same way as I did in ver0.0.3-1, NO issue observed.

May I take the liberty of asking you to fix the "Kill" pop-up message during the system start-up ?! It's not supposed to be "good" when user should see it every time after system boot up. Sorry, it's just my personal opinion.

However, I would express my sincere appreciation for your great job on this.

p.s.: I'd been tried the way of Manual SCIM on/off switching, but it brought some issue to my N900 and I had to re-flash the system. haha~

http://freaxer.blogspot.com/2010/09/...-and-scim.html