OMFG
KERNEL
POWER
v47
IS
COMPATIBLE
WITH
BLEEDING
EDGE
DRIVERS

Can we, like, autoredirect everyone to this post when they type "bleeding edge drivers" into the forum? (Edit: The above isn't directly at you F2thak, or anyone specific, I'm just getting annoyed of seeing the same question cropping up for over a month)

And on a technical note - "install" and "load" are different things. The drivers are always permanently "installed", unless you went and erased them. They aren't permanently loaded, but that's another matter.

As for how to do it - you can set up a script (based on load.sh, or which executes load.sh), and stick it into /etc/event.d/ <-- no I don't personally do it, but it shouldn't be too hard to figure out if you look through some of the other scripts in there. Then just play around with seeing how late in the boot process you need to run it to end up with the bleeding edge drivers loaded.