piece of advice.

1. use high heat solder to clean the large pins and quickly clean the small pins
2.clean the area with methanol/nail polish removal
3. Get a new USB female type B
4. Align the pins correctly (small pins)
5. soldering it back on the board (large pins with high heat, small pins with low heat 1mm tip with magnifying glass)
6. scratch the board to the copper and lead it to the USB to reinforce
7. epoxy it afterward to solidifying and stability
8. check the small pins with magnifying glass
9. clean it up again with nail polish removal
10. Check the pins again before put it back together.

These are what you need to do