Originally Posted by GadgetDave

It looks like Diablo gives a nice improvement in the ability to run IPv6 for those that are interested. Launch an xterm (or ssh in from another machine), then run:

Code:

/usr/bin/osso-ipv6-enable.sh --enable

This will load the appropriate kernel modules (most importantly ipv6.ko), and setup the appropriate key(s) using gconftool.

I was all set to build my own custom kernel (or at least kernel module), and low an behold, Nokia made it very easy for me.

Also, take a look at /etc/init.d/osso-ipv6

Run the following command(s) to check your ipv6 config:

Show your IPv6 addresses (ifconfig is part of busybox, not IPv6 enabled in Diablo):

Code:

ip -f inet6 addr show

Show your IPv6 Neighbors (should show router if IPv6 RA is setup):

Code:

ip -f inet6 neigh show

Show your IPv6 routing table:

Code:

ip -f inet6 route show

Show your IPv6 kernel parameters:

Code:

sysctl -a |grep ipv6

This is working for me without any major issues. I had already set the browser to enable IPv6 using the "about:config" mozilla trick, and set network.dns.disableIPv6 (bool) to false. (It defaulted to true)

They have not updated the howto for Diablo yet, but there is still very useful information.

diablo 3 barbarian skills

Those that have used IPv6 will know what I mean.

--GadgetDave