Thread: overclocking kernel modules + UI for PR1.3 [ko v1.5.4] [ui v1.2.7]
View Single Post
Creamy Goodness is offline Creamy Goodness
2012-04-26 , 23:16
Posts: 1,463 | Thanked: 1,916 times | Joined on Feb 2008 @ Edmonton, AB
#393
Originally Posted by Dragoss91 View Post
My device acts weird at similar frequencies . Here's what I tested so far and results , I want to know if someone else is getting this .
I also turned on SR but results are same

1. 1350mhz - 1.3875v : stable
2. 1360mhz - 1.3875v : stable
3. 1370mhz - 1.3875v : extreme lag and freezes , device is inoperable
4. 1370mhz - 1.4v : same as point 3
5. 1370mhz - 1.4125 : same 3
6. 1370mhz - 1.4250 : same

And every frequency above 1370mhz makes the device inoperable , no matters what voltage or sr .

I see an improvement in conky with this new opptimizer , now I'm not seeing anymore only max frequency , the frequency goes also to 300 or 600mhz .
Probably the CPU is slowing itself down due to overheating, we will need some more reports and research to be sure.

Originally Posted by Sniper_swe View Post
Working great with open mode kernel (nitdroid kernel)
Apply on startup is not yet supported?
Apply on startup is tricky, we need another script or daemon and it needs to be very careful to not apply the same frequency and voltage 2x in a row if you get an unexpected reboot, otherwise you can get a brick (you would need to reflash but if we apply the bad settings too early you might not be able). To avoid leaving this in development another week, the initial version will not have this feature.
__________________
Last edited by Creamy Goodness; 2012-04-26 at 23:19.
 

The Following User Says Thank You to Creamy Goodness For This Useful Post: