Thread: overclocking kernel modules + UI for PR1.3 [ko v1.5.4] [ui v1.2.7]
View Single Post
Creamy Goodness is offline Creamy Goodness
2012-04-28 , 18:37
Posts: 1,463 | Thanked: 1,916 times | Joined on Feb 2008 @ Edmonton, AB
#430
Originally Posted by Dragoss91 View Post
Conky seems to be a stronger benchmark than opptimizer's one . After doing 16000 iterations at 1300mhz and 1.275v I've open conky then phone freezed and rebooted .
That's funny, I did verify the benchmark uses 100% cpu, and the math is floating point. Maybe Conky does a lot of integer math lining up all the fields and that part of your CPU couldn't handle it. I'll try to add some more interesting benchmarks when I have time.


Originally Posted by Mikkosssss View Post
I get same

~ $ /home/user opptimizer_1.5.1_armel.deb
-/bin/sh: /home/user: Permission denied
~ $
I guess I forgot to tell you to type opensh before trying to incept the packages? Try that, I will update the first post.

Originally Posted by Timpaxi View Post
when i try to incept opensh it gives me permission denied...
So, you are stuck on the inception website part still? I think you just need devel-su or "normal root" before you can incept opensh. Double check the instructions were followed completely.

Originally Posted by Manatus View Post
...
With defaults settings 'vdata->u_volt_nominal' shows 1375000, so basically it just seems that if I use only cpu slider, the smart reflex freezes the phone at 1375000 with both UI or with echoing it.
If you don't enter a voltage, your default should be less than 1300000. SmartReflex usually lowers it quite a bit. The one that says optimized gets used if SmartReflex is on, otherwise it's dyn_nominal or something. I wrote the formula it uses in the first post, or just look at the field that says omap_getvoltage, that one is requested from the voltage controller and should be correct.
__________________
Last edited by Creamy Goodness; 2012-04-28 at 18:44.
 

The Following 3 Users Say Thank You to Creamy Goodness For This Useful Post: