Win7 64bit...
i think i need to cold flash but ive tried this from the wiki and it gives an error about 2nd.bin not found
flasher-3.5 -c -h RX-51:2101 -2 2nd.bin-RX-51\:2101\,2102\,2103 -s secondary.bin-RX-51\:2101\,2102\,2103 -S usb
have also tried:
flasher-3.5 -h <device>:<hwrev> -F <fiasco> -c -S usb
"no suitable device found"
and the one time it did begin to flash i got:
USB device found found at bus bus-0, device address \\.\libusb0-0002--0x04
106.
Waiting for ASIC id...
Got 69 bytes.
ASIC ID:
05 01 05 01 34 30 07 57 13 02 01 00 12 15 01 ea
f7 31 b0 26 a0 59 4e bc f4 4c 9a 92 42 cf 1d 8d
f1 e9 74 14 15 01 87 3b 4d cd ca f5 44 4d 24 ec
b2 ac 95 53 88 41 4f ab cd 66 15 09 01 f7 48 8f
28 a0 27 e5 b3
Sending 2nd image (zu bytes)... done.
Sending ping... usb_bulk_read: No error
failed.
Sending ping... usb_bulk_read: No error
timeout!
failed.
Sending ping... usb_bulk_read: No error
timeout!
failed.
Sending ping... usb_bulk_read: No error
timeout!
failed.

not sure what is the correct cold flash command and if any of these are the exact command either.
the device flashes the fiasco easily (not the emmc "not suitable device found")
doing my head in...