Originally Posted by mihkel

Tried it, but still no change,
I can't set an IP address to to the phone because it will not stay connected to the PC with a custom kernel. Probably why I can't clear the MALF state either.

dmesg gives me:

Code:

[  915.000065] usb 1-2: new high speed USB device using ehci_hcd and address 17
[  918.154552] usb 1-2: USB disconnect, address 17
[  920.030081] usb 1-2: new high speed USB device using ehci_hcd and address 18
[  920.762702] usb 1-2: USB disconnect, address 18

It disconnects as soon as I load the custom kernel for your tool or for flasher.
After it disconnects, lsusb won't list the phone - it's as if it wasn't connected to the computer at all.

With just

Code:

sudo flasher -i

the phone stays connected to the computer and lsusb gives me:

Code:

Bus 001 Device 024: ID 0421:0105 Nokia Mobile Phones Nokia Firmware Upgrade Mode

Do any of you know, if the phone is still supposed to boot and vibrate with the proximity sensor and screen disconnected?
I bought a replacement screen for the phone from eBay so I don't believe that it's faulty. It COULD be a faulty sensor, but I really doubt it because I just replaced it as well..