Thread: ps3 sixaxis on n9 (can't change bt address
View Single Post
torcida's Avatar
torcida is offline torcida
2013-01-18 , 21:06
Posts: 84 | Thanked: 43 times | Joined on Nov 2012
#7
Hello,

I found a quite easy way to run the SIXAXIS on the N9.

1. Install this: SixaxisPairTool (Source: Dancing Pixel Studios)
2. Type in your Bluetooth Adress
3. Now go on with the Setup (Source: EmuMaster Wiki):

1.Run terminal
2.Type devel-su to get needed privileges (rootme is the default password)
3.Kill bluetooth daemon by typing killall bluetoothd (repeat it few times quickly until you see a message that bluetoothd is not running)
4.Now configure bluetooth device ◦/usr/sbin/hciconfig hci0 up
◦/usr/sbin/hciconfig hci0 lm master
◦/usr/sbin/hciconfig hci0 piscan

5.Run SixAxis Monitor from the main menu
6.Click on "Start" button
7.Now take your sixaxis and press button with PS logo
8.Sixaxis should start blinking now and after couple of seconds only one LED stays on
Here you have a demonstration of how it works.
Last edited by torcida; 2013-01-18 at 21:46.