View Single Post
ArchiMark's Avatar
Posts: 414 | Thanked: 109 times | Joined on Mar 2007 @ Silicon Valley
#364
Originally Posted by mlwane View Post
I have a suggestion for you. Try to remove "20-archlinux.item" from "/etc/bootmenu.d/", and then create a new, lets say "21-archlinux.item" file again. Also try to type the configuration manually, not just copy-paste, while paying attention there are no mistakes.
Thank you!

Did as you suggested and this time no error messages from u-boot-update-bootmenu!

btw, I did not copy-paste before, so, much have been a typo....

Well, just did reboot and I saw and selected Arch....Yeah!!!

Unfortunately, it does not boot up Arch though....get the following console error messages....

Code:
localhost login:   [   4.377685] omap_12c omap_12c.2: controller timed out
[    4.784729] bcm2048 3-0022:  BCM 12C error!
[    4.786285] bcm2048 3-0022:  Is Bluetooth up and running?
[    5.885070] tpa6130a2 2-0060: Write failed
[    5.885253] tpa6130a2 2-0060: Failed to initialize chip
[    5.932525] et8ek8 3-003e: read from offset 0x1263 error -121
[    5.933380] isp_register_subdev_group: Unable to register subdev et8e8
[    6.032714] EXT4-fs (mmcblk0p4): unable to read superblock
[    6.034698] smia-sensor 2-0010: read from offset 0x0 error -121
[    6.102020] EXT4-fs (mmcblk0p4): unable to read superblock
[    6.110565] EXT4-fs (mmcblk0p4): unable to read superblock
[    6.390136] rx51-audio rx51-audio: asoc: failed to init TLV320AIC34: -19
[   6.390411]  asoc: failed to instantiate card RX-51: -19
[   6.405364] rx-51-audio rx51-audio: snd_soc_register_card failed (-19)
I can take care of the error regarding formatting of mmcblk0p4....forgot about that partition....just formatted mmcblk0p5 to ext3 for Arch install....

Any suggestions now?

Thanks!
__________________
Mark
Silicon Valley Digerati

Nokia N900
Previous: Nokia N810 & N800