Thread: Producing Qwerty OtherHalf --order counter: 75/75 --ordering closed
View Single Post
dirkvl is offline dirkvl
2014-01-22 , 10:23
Posts: 1,104 | Thanked: 5,652 times | Joined on Feb 2010 @ Holland
#352
Originally Posted by TNL View Post
For 3D printing maybe Shapeways could provide any help? It is also based in Eindhoven, so shipping costs may be low.

For the design you now have, is there any possibility to make holes for the cam and flash, since the keyboard has some room left?
Good one, thanks for the link!

The camera and flash will be exposed when the keyboard is slided out. I can make it exposed when slided in, but that will mean the keyboard is about 10 mm to the right of the center. And you will have a hole on the left side next to your kb.
So, possible:yes, ugly:yes.
 

The Following 2 Users Say Thank You to dirkvl For This Useful Post: