Thread: [Announce|WIP] Tiny Tiny RSS Reader for Meego
View Single Post
cnlpete is offline cnlpete
2014-04-04 , 10:48
Posts: 44 | Thanked: 75 times | Joined on Feb 2013 @ Germany
#49
Originally Posted by nodevel View Post
I just installed it on the device and it works great. No issues whatsoever. Thank you!
thanks

Originally Posted by nodevel View Post
EDIT:
Found some issues afterall:
  • it doesn't automatically mark articles as read even though the option is active in Settings
fixed, this was due to a dev-setting i used for testing, which i forgot to remove

Originally Posted by nodevel View Post
  • special characters (like řšč...) are not shown in the article list (they're fine in article view, though)
for me german umaltus (äöü) as well as a few others (é) are working in the feeditems list. if they don't for your device, can you provide me with an rss feed in which they are not working?

Originally Posted by nodevel View Post
  • the 'Show All' option is not remembered - the app always starts with the 'Show Unread' option
added to my todo list

Originally Posted by nodevel View Post

I have some suggestions as well, but those are not critical:
  • app cover could be used to go through new articles, so you could check them without going into the app
a proper cover is on my todo list aswell

Originally Posted by nodevel View Post
  • the 'Settings' and 'About' options could be visible only in the folder view - it would make space in the article view for some more options
done

Originally Posted by nodevel View Post
  • could you add options to show Special->New or Special->All on startup?
added a note on my todo list

Originally Posted by nodevel View Post


PS: I'm sorry I didn't give you any advice about the armv7hl target - I've got the target set up, but I remember I originally had issues with it as well and I can't recall the exact steps I had to take
Was actually pretty easy, just had to use the 'Deploy' function in the qtcreator i was using build / execute before and the execute button was not available for the arm target...
 

The Following User Says Thank You to cnlpete For This Useful Post: