Thread: RX-51 BME Replacement
View Single Post
Estel's Avatar
Estel is offline Estel
2014-10-03 , 23:24
Posts: 5,028 | Thanked: 8,613 times | Joined on Mar 2011
#34
Originally Posted by Kossuth View Post
but it requires some work to ensure that the battery drains slowly enough at the end and only then it is connected back to charger.
Or just charge it to full, disconnect (VDC 1, check with BNF when in doubt), then just use it normally, and let it turn itself off due to low power. It will shutdown safely, and get calibrated just before.

Originally Posted by Kossuth View Post
I would like to know is the any mechanism in the BME replacement that caused the calibration to be erased
BME replacement or not, the chip mark itself as "uncalibrated" after 32 charging cycles without calibration. Again, you can check that with BNF ("Calibration required" flag).

/Estel
__________________
N900's aluminum backcover / body replacement
-
N900's HDMI-Out
-
Camera cover MOD
-
Measure battery's real capacity on-device
-
TrueCrypt 7.1 | ereswap | bnf
-
Hardware's mods research is costly. To support my work, please consider donating. Thank You!
 

The Following 5 Users Say Thank You to Estel For This Useful Post: