Thread: [Announce]N900 Intergrated Qi Wireless Charging, No Soldering Required.
View Single Post
impeham is offline impeham
2014-10-10 , 23:13
Posts: 669 | Thanked: 433 times | Joined on May 2010
#51
Originally Posted by biketool View Post
If I position my phone perfectly for a fast charge on my Qi pad it gets to about 40C but never so hot that it is uncomfortable to touch.
Are you getting good charging?
I made some changes - glued magnets on the Qi charger to hold the phone, and there is now a distance of 0.5cm between the receiver and the charger. The temp seems fine so far - moving between 40 to 50 degrees.

I don't know what is considered good wireless charging - i'd say i get something like 25% for an hour (1350ma battery).

The phone charges until it gets sometimes to ~93% or 100% and then the charging goes off (the charging light on the transmitter is off). after some time without touching it, the screen turns on and the charging starts again. is this normal?
 

The Following User Says Thank You to impeham For This Useful Post: