this is i think one of those messages you type while you think, and then don't read it back. i cannot 'make cheese out of it'.

anyway, starting on a job i have been avoiding so far: changing the keyboard pcb to have circular domes instead of semi-oblong ones.
circulars have -i think- a little higher push-force, which is better since they will under slight tension by the keypad membrane. but mainly it makes ordering domesheets easier, because i only have to give list of locations and no worries about orientation.



i mentioned here already i will probably be going for through-hole fat pogo-pins instead of emi fingers? cleaner look, more durable.

these will be on next test pcb for keyboard piece.

also, waiting on the pcb for in the toh cover, that is the first final-release candidate. if that one is perfect i will put some fancy pcb art on it and can start setting production up for it.