maemo.org - Talk - View Single Post - Jolla OtherHalf OLED display / toholed

	pichlo	2015-01-26 , 13:47
	Posts: 6,453 \| Thanked: 20,983 times \| Joined on Sep 2012 @ UK	#384

Thanks, kimmoli! That's exactly what I was after.
The results:

The interrupts were going up. Quite a lot when I was just fiddling with the switch with a screwdriver, only by one when I attached and detached a TOH.
The tod daemon is running and active. I killed it on Friday to see what happens and it restarted on its own so the uptime is since Friday but it is active.
Something happens when I run dbus-monitor but I am not sure what to make out of it. For completeness, I also ran it without grep and here is (a part of) the output:

Code:

signal sender=:1.7 -> dest=(null destination) serial=46 path=/com/jolla/tohd; interface=org.freedesktop.DBus.Properties; member=PropertiesChanged
   string "com.jolla.tohd"
   array [
      dict entry(
         string "Docked"
         variant             int32 1
      )
   ]
   array [
   ]
signal sender=:1.7 -> dest=(null destination) serial=47 path=/com/jolla/tohd; interface=org.freedesktop.DBus.Properties; member=PropertiesChanged
   string "com.jolla.tohd"
   array [
      dict entry(
         string "Ready"
         variant             int32 1
      )
      dict entry(
         string "TOHID"
         variant             string ""
      )
   ]
   array [
   ]

Am I right to assume that TOHOLED does not need NFC anyway? I can live quite happily without swapping ambiences

__________________
Русский военный корабль, иди нахуй!

Quote & Reply |

The Following User Says Thank You to pichlo For This Useful Post:
juiceme