not a complaint at all, only a slight warning and looking for help...
I managed to drop my TOHKBD again, this time it was fatal to the toh-part as seen in the picture below.

Advice (mainly to myself): Be even more carefull with your precious then before this post... I managed to glue it with 2 component glue but it looks so ugly i refrain from posting it

What i am looking for is the .stl file to reprint it at shapeways.
I found different links to it but am unsure as a 3d print noob. Could someone post the definate file and maybe even get into detail what options to select at shapeways.
Thanks a lot and again, no complaint. Just me beeing to clumsy after 12hours of kitchen work...