@Kabouik: I'm going back to China later this week to finalise the Moto keyboard Mod business. The moulding of the sliding frame plus the hinge indeed is a tough job but we are close to finish. By the time Moto Keyboard is shipping I will start kicking off Lauta-revival project. With the all in one sliding keyboard, thickness can be greatly reduced (>7mm reduced from Moto Mods) Rather than Pyra, I want to make a more general keyboard device for every-day use. A good looking product, and can last at least for a few years. Planned: - LTE Cat6 support (number of bands depend on the upfront cost. Likely to be 4 or 5 so there will be 2 versions) - Full QWERTY support with the hinge that can lift the screen (Not exactly same as N950/Lauta but more like Touch Pro 2, you can change the angle) - 5.0"+ screen. I know this will be a disappoint for some, but you can't find anything reliable and decent below this size, unless someone gives me 1M USD and I can develop a 4-inch decent solution myself... - Part of the device will use metal, similar to the N950 - again I want everyone can proudly show the device unlike some chunky monsters... And the overall thickness will be controlled. Likely around 12mm. (To ensure a good sized removable battery) - User can of course remove and replace the battery, when it dies - Regarding OS - this requires some work and need to analyse the total cost. But I can promise bootloader won't be locked and won't only be AOSP. (Not even considering pre-load with Google service) - By JUL/AUG when I close the Moto Keyboard project and Youyota production line starts, I will reveal more design work and pictures...