Hi there - just got a wimax for Christmas and decided to give this a try. Everything checks out OK until I get to the final reboot where I should get to start up from the internal memory card.

I see the bootmenu OK but the control pad is disabled and then after 10 seconds or so I get the following error message
"WiMax:
Self test RF#2 failed, try to reboot the device.
If the problem persists, perform software update
or contact service."

I successfully reflash the device and start over. I can even install the boot-menu and then restart directly to the internal but I get the error when I add the memory card partition to the bootmenu.

Also, separate question - I've read that using a memory card as swap can shorten the life of the card. Since the wimax has an embedded card what is the best way to handle the partitioning and swap for the wimax? should I only be doing this on the external card?

thanks