I used the new 0.15 version with AlarmD integated into it - and liked it.

Yes the first load is slow and it "seems" as if it has crashed or frozen.
But all subsequent runs are fine - so no issues there.

Alarm worksed fine for me - I set up one Alarm theu Flip Clock and also had another alarm already set thru the Big Statusbar clock up on top.

Both alarms (different times) kicked off at their respective times - so Flip clock works just as fine with AlarD integrated.

One issue that I noticed - I connect the N810 on power all night and have set it to not sleep when connected to power.

On the new Flip clock version I see that the time stays the same - set at 11:54 PM even in the morning and has not changed - untill I touch the screen and then it refreshes to show the current time.

This was not the case with the older version - the time would change as and when I looked at the clock during the night.

So something seems wrong here - if its on powersave mode - then I understand the time will refresh only when the device wakes up - on touching the screen, but on charging mode without any power save enabled - it should refresh the time so that the time on the screen which is visible all times reflects the current time always.