Thread: n800 HW serial port
View Single Post
ioioio is offline ioioio
2009-09-26 , 02:35
Posts: 86 | Thanked: 55 times | Joined on May 2009
#9
http://www.bu3sch.de/joomla/index.ph...serial-console



Enabling the serial console in software

The serial console has to be enabled in software before it can be used. This can be done using the 0xFFFF utility. At least version 0.3.2 is needed. Read the documentation of that software before using it! After you read the documentation, you can enable the serial console by connecting the USB cable and entering this command:

sudo 0xFFFF -r 1 -f 0x10

After that switch the n810 device on. 0xFFFF will detect it and change the parameters. You can use

sudo 0xFFFF -R

to reboot the device afterwards.
 

The Following User Says Thank You to ioioio For This Useful Post: