Thread: Laser-Cut Stand for N900
View Single Post
fake is offline fake
2010-02-23 , 20:41
Posts: 277 | Thanked: 348 times | Joined on Nov 2009 @ Fargo, North Dakota, USA
#494
Originally Posted by slender View Post
Got my black stand today.Ordered it 12.02. looks nice. Thank you!
I like smell of it
Cool!

Originally Posted by slender View Post
btw. is it intentional that nonslip coating is only under side pieces?
Yes, that's intentional. On some of my prototypes, when I put non-slip on that back brace, it would make a pivot for the N900 to tilt on. As a result, on the stands I actually mailed, the non-slip coating is only under the side pieces.

Further, on the last two batches of stands, I've been thinning the amount of non-slip toward where the back brace slots in, to prevent any accidental pivots from forming while the rubber substance dries...