Hi guys, I have tried to setup the development environment with MADDE on Windows according to the tutorial on wiki. I am having trouble with my N900 restating when I connect it via the USB cable. The case is following. I run Mad Developer and load the g_ether module. I configure the IP address and other connection properties. The module loads OK and the usb interface IP configuration is displayed in Mad Developer. Then I connect the device via USB cable and select PC suite mode. After a couple of seconds my N900 is restarted (and after the startup g_nokia is loaded). If I connect via USB cable first and try to load the g_ether module N900 is restarted immediatelly when the module load is initiated. So I guess the problem is in some clash of my windows machine with g_ether module on N900. Have anybody experienced this? Any hint? I am stuck :-(