Thread: Laser-Cut Stand for N900
View Single Post
fake is offline fake
2010-03-23 , 03:05
Posts: 277 | Thanked: 348 times | Joined on Nov 2009 @ Fargo, North Dakota, USA
#576
Originally Posted by hawaii View Post
Any plans to put felt or rubberizing on the bottom of the stands - where they contact the surface of whatever they are on - to minimize loud vibration noises?

Or am I just a ninny and that's already there?
This new acrylic stand is non-slip but will probably still vibrate against your desk because the rubber bands are only on the back. One possibility I've been investigating is little microfiber mats that could be included w/each stand.

I would probably have to see a little more interest, though. Orders have almost stopped, so it doesn't make a lot of sense for me to do yet another redesign.

Any suggestions welcome -- I will look into more substantial stylii.