__________________________________________________ __ INSTRUCTIONS FOR FLASHING FROM A PC __________________________________________________ __ 1: download and install maemo_flasher-3.5 Flasher download: http://tablets-dev.nokia.com/maemo-dev-env-downloads.php 2: download and put the kernel image in the flasher directory on your PC (C:\Program Files\maemo\flasher-3.5\). Make sure you save the file with no extension ie.txt at the end. Just leave it as 'zImage-800mhz' Kernel image download: http://www.saunalahti.fi/crailt/ 3: turn off your device 4: hold the 'u' letter and plug in the usb cable. PC should detect the phone in flasher mode. You should now see a 'USB' icon in the top right of the nokia screen. 5: type this command in Maemo Flasher 3.5: ___________________________________ flasher-3.5 -k <path-to-image> -f -R ___________________________________ example: flasher-3.5 -k zImage-800mhz -f -R 6: your done should take 1 second __________________________________________________ __ Tip **Flash your kernel to run this image 'zImage-800mhz' way less chance of your device overheating and causing damage. any higher and you are one crazy bastard Caution **Stay away from any files which end in ‘dsp’ unless you know what you are doing. **Avoid using any kernel which runs the device at more then 900mhz unless you know what you are doing. **better yet stay away from any overclocking unless you understand the risk of what you are doing. __________________________________________________ _ ************************************************** ******************************* __________________________________________________ __ INSTRUCTIONS ADDING A DESKTOP HEAT WIDGET __________________________________________________ __ 1: download and install ‘Desktop command execution widget’. I think it’s in Extras-devel 2: add the widget to your desktop 3: go to the setting of your widget by holding the screen, or tapping once in a empty space and click the box which drops down on the top right. Click on the ‘tool’ on the widget to get to the settings 4: Once in the widget set up click ‘add Cmd’ 5: a box should appear with two fields. Add the following ___________________________________ Titile: Heat ___________________________________ Command: cat /sys/devices/platform/omap34xx_temp/temp1_input ___________________________________ 6: click ‘save’ then ‘save’ again 7: your done: D. if you want you can tweak the widget a little more in the settings. Tip **the desktop command widget doesnt refresh unless you scroll or click on it by default. Some users will think the temp is stuck but its not **if you want live changes click on the settings again. untick update on scroll and press. set up an update interval in the settings ranging from 30sec to 12hours ***this might have a battery impact im not sure????? or have update on scroll, press ticked and intervals selected. __________________________________________________ __