Undervolting kernels:


These should in theory be safe to run as the 800mhz mode
runs with less voltage than the 500mhz mode uses normally,
while the other modes run with even much less voltage.

Heavy undervoltage, 800mhz max speed by default. 250mhz minimum clock with less than 125mhz voltage.
1100mhz activateable by a person with knowledge, however 1100mhz mode runs on OVERVOLTAGE!

UNSAFE TO TRY 1100mhz unless you want to break your device FOR REAL!!!!!!!
1100mhz mode left there only for quick demonstration purposes, but should by no means be used constantly as the cpu lifetime will be reduced A LOT.
This kernel also undervolts the DSP.
Most propably bricks your device if your chip isnt of good patch. Be prepared to flash the stock one back.
CPU: 250mhz / 375mhz / 500mhz / 800mhz / ((1100mhz))
DSP: 90mhz / 180mhz / 360mhz/ 400mhz / 430mhz