Hi Smoku,

Sorry to ask mate, but i've read the whole thread and you mentioned my problem before but the method you mentioned is not working for me. I'm now getting the
"Accept connection with device?
PLAYSTATION(R)3 Controller"

And then the flashing lights after a period of me being asked to let the pad connect. (interestingly enough, phones BT goes blue even though lights are flashing, know this as did a hard reset of pad when noticed this behaviour and sure enough my phone dropped the BT signal it had).
The 'flashing lights only' state of the device will persist unless I reinstall sixad, then it reverts to asking me the eternal question for another 5 mins.

Unfortunatly, I have had sixad working fine for the past 2 months, today I had to reflash my phone, and even though the restore went fine, and all my applications were re-installed flawlessly, it stopped working.

First thing I did was take all BT related s/w off the phone and reinstall, and still nothing.
Next I reset the pad using glovepie (a method which has worked for me in the past), and then i was greated with the above message.

I tried manually starting as you said, and sixad wil say "connection error 'no input / no output'" or something very similar.

Tried everything i can dig up online, am at my wits end, save a full emmc re-flash, i'm totaly out of ideas.

Currently in Solihull, wanting to play some shadowrun through the hotel telly

Help me obiwan, you're my only hope!