Thread: buying AC-10x charger
View Single Post
tzsm98's Avatar
tzsm98 is offline tzsm98
2010-04-25 , 23:08
Posts: 500 | Thanked: 437 times | Joined on Nov 2009 @ Oklahoma
#5
My AC-10U has a matte finished panel from which the prongs protrude. Above the centerline as you hold the adapter in front of you so you can read the writing are two screwheads of a non-standard type. These are at the outboard edges.

A glossy border surrounds a section of this panel adjacent to where the power cord exits. This reads FWHK; a V in a circle; two concentric quares, The UL symbol with C on the left and US on the right; and Listed 11FH I.T.E.Power Supply (on three lines).

On the side is lightly engraved or printed NOKIA and a lot of hard to read information and a small 3D bard code. It says, in part, "For Indoor Use Only"

The top of the adapter has a glossy panel with a matte edging; the panel is marked with a raised "NOKIA".

The tip of the power cord has an incused "B" in a raised square panel and a raised USB symbol below not on the square panel but in a shallow releif. This assumes you are holding the adapter end so you can read the "B" in it's normal orientation.

I hope this helps. The X charger may be entirely different but this is what a known genuine AC-10U looks like. I can not see any reason for the phone end to vary based upon the wall end.
 

The Following User Says Thank You to tzsm98 For This Useful Post: