Thread: Overclock the N900?
View Single Post
Tigerite is offline Tigerite
2010-05-20 , 08:17
Posts: 284 | Thanked: 320 times | Joined on May 2010 @ Peterborough, UK
#3929
Originally Posted by brianchen0321 View Post
i brick my device after updating v34.
can somebody help please?

after updating, i load my setup by kernel-load.
and i click on status bar, it reboots suddenly and stuck before pin code input interface.

i try to reflash kernel by maemo flashser, but it didn't work.
please help. thanks.
This happened to me too. The v34 that I had downloaded was corrupted somehow, and so I tried to flash a menagerie of v33 and v34, but I think the headers were also mangled. It was fine until I shut the phone down and then it wouldn't boot, nor charge as it would do a reboot loop when plugged in to the USB mains.

I then had to wait till this morning to fix it,as I'd left my USB cable at work - thankfully, 5 minutes later it was all working again and I didn't have to reflash everything, only the kernel using:

Code:
flasher-3.5 -k zImage-STOCKpr1.1.1 -f -R
So, all apps still intact just a bit of a pain to be without the phone last night. Just sharing this in case anyone has problems with the kernels, a full reflash should not be required, just use the stock PR1.1.1 from Lehto's site. If you've upgraded to the PR1.2 RC then it might be different though..