hi all,

i just overclocked my device to 'ulv 500 750 '

however everytime i reboot my device (no crash, just off and on again) ,
the frequency goes back to the standard 250 - 600.

i remember reading on of titan's post saying that , only when there is a crash or accidental reboot that wil cause the kernel to not run properly.

everytime i type in

I can see from conky and 'kernel-config show' that the overclock was successful, but when i reboot, everything just goes back to standard and its like i've never overclocked before =(

anyone knows whats going on here? is anyone experiencing the same problem?

thanks