View Single Post
Posts: 543 | Thanked: 151 times | Joined on Feb 2010 @ Germany
#1
Dear Maemo Community,

I was positive surprised today that version 1.2 finally released, I tried to install it of course directly.

So I started the NSU on my XP Dell notebook and it couldn't find my phone at all (It worked fine before), equal what I tried nothing worked.

Right, so I tried the manual way as it is described in the news. Downloaded flasher 3.5 and used the command "flasher-3.5.exe -F RX-51_2009SE_10.2010.19-1.002_PR_COMBINED_002_ARM.bin -f" which worked fine, then I used "lasher-3.5.exe -F RX-51_2009SE_10.2010.13-2.VANILLA_PR_EMMC_MR0_ARM.bin -f -R" and the following stuff comes:

...
Booting device into flash mode.
Suitable USB device not found, waiting.
Windows can't install a device (Which is not even shown in the device manager) and it stucks there forever.

- Yes, I tested different drivers and uninstalled the old ones before
- I tested different modes on the phone without success
- I used the search function and didn't found a valid solution

I tested it also on my other notebook (ASUS G73) with WIn7 64bit and there it detect no phone at all (This was the point where I wanted to hit my phone with a big knife).

So is there a way to fix this problem or reset the eMMC manually somehow? I have a lot of mess installed and the phone is not really smooth at all, still 1.2 seems to be installed fine cause it shows "Version: 10.2010.19-1".