maemo.org - Talk - View Single Post - [Android] NITDroid V2 & Multiboot Development And Announcement Thread

cricker	2010-07-26 , 13:12
Posts: 10 \| Thanked: 8 times \| Joined on Jan 2010	#374

Can someone help me out?

I followed the instructions on the NITDroid website and installed a the 5.3 version of the NIT droid software. It booted fine without an issue.

I later installed (after a complete wipe of my N900) Steve's 6.0 release. The bootloader starts without an issue, I select the option to boot into nitdroid and it starts to load. However, at about the spot where the previous version goes to the Matrix-style loading screen, I now get a blank screen with only a little blinking cursor in the top left corner. I left it overnight and same thing in the morning.

After rebooting, I went back into the Maemo software, mounted the /and partition, and started digging through the logs. I came across the following, which I think is the point of the problem. I've since re-installed and tried again, and some issue. Any ideas?

Code:

[ 07-26 03:33:44.622   380:0x17c I/SurfaceFlinger ]
SurfaceFlinger is starting

[ 07-26 03:33:44.622   380:0x184 I/SurfaceFlinger ]
SurfaceFlinger's main thread ready to run. Initializing graphics H/W...

[ 07-26 03:33:44.646   380:0x184 E/FramebufferNativeWindow ]
couldn't open framebuffer HAL (No such device)

[ 07-26 03:33:44.661   380:0x184 D/libEGL   ]
loaded /system/lib/egl/libGLES_android.so

[ 07-26 03:33:44.677   380:0x184 D/libEGL   ]
loaded /system/lib/egl/libEGL_POWERVR_SGX530_121.so

[ 07-26 03:33:44.700   380:0x184 D/libEGL   ]
loaded /system/lib/egl/libGLESv1_CM_POWERVR_SGX530_121.so

[ 07-26 03:33:44.731   380:0x184 D/libEGL   ]
loaded /system/lib/egl/libGLESv2_POWERVR_SGX530_121.so

[ 07-26 03:33:44.739   380:0x184 W/libEGL   ]
0: eglInitialize(0x1) failed (EGL_BAD_ALLOC)