Can someone help me out? I followed the instructions on the NITDroid website and installed a the 5.3 version of the NIT droid software. It booted fine without an issue. I later installed (after a complete wipe of my N900) Steve's 6.0 release. The bootloader starts without an issue, I select the option to boot into nitdroid and it starts to load. However, at about the spot where the previous version goes to the Matrix-style loading screen, I now get a blank screen with only a little blinking cursor in the top left corner. I left it overnight and same thing in the morning. After rebooting, I went back into the Maemo software, mounted the /and partition, and started digging through the logs. I came across the following, which I think is the point of the problem. I've since re-installed and tried again, and some issue. Any ideas? Code: [ 07-26 03:33:44.622 380:0x17c I/SurfaceFlinger ] SurfaceFlinger is starting [ 07-26 03:33:44.622 380:0x184 I/SurfaceFlinger ] SurfaceFlinger's main thread ready to run. Initializing graphics H/W... [ 07-26 03:33:44.646 380:0x184 E/FramebufferNativeWindow ] couldn't open framebuffer HAL (No such device) [ 07-26 03:33:44.661 380:0x184 D/libEGL ] loaded /system/lib/egl/libGLES_android.so [ 07-26 03:33:44.677 380:0x184 D/libEGL ] loaded /system/lib/egl/libEGL_POWERVR_SGX530_121.so [ 07-26 03:33:44.700 380:0x184 D/libEGL ] loaded /system/lib/egl/libGLESv1_CM_POWERVR_SGX530_121.so [ 07-26 03:33:44.731 380:0x184 D/libEGL ] loaded /system/lib/egl/libGLESv2_POWERVR_SGX530_121.so [ 07-26 03:33:44.739 380:0x184 W/libEGL ] 0: eglInitialize(0x1) failed (EGL_BAD_ALLOC)
[ 07-26 03:33:44.622 380:0x17c I/SurfaceFlinger ] SurfaceFlinger is starting [ 07-26 03:33:44.622 380:0x184 I/SurfaceFlinger ] SurfaceFlinger's main thread ready to run. Initializing graphics H/W... [ 07-26 03:33:44.646 380:0x184 E/FramebufferNativeWindow ] couldn't open framebuffer HAL (No such device) [ 07-26 03:33:44.661 380:0x184 D/libEGL ] loaded /system/lib/egl/libGLES_android.so [ 07-26 03:33:44.677 380:0x184 D/libEGL ] loaded /system/lib/egl/libEGL_POWERVR_SGX530_121.so [ 07-26 03:33:44.700 380:0x184 D/libEGL ] loaded /system/lib/egl/libGLESv1_CM_POWERVR_SGX530_121.so [ 07-26 03:33:44.731 380:0x184 D/libEGL ] loaded /system/lib/egl/libGLESv2_POWERVR_SGX530_121.so [ 07-26 03:33:44.739 380:0x184 W/libEGL ] 0: eglInitialize(0x1) failed (EGL_BAD_ALLOC)