Thread: question about rd mode.
View Single Post
JMills is offline JMills
2006-01-18 , 20:45
Posts: 48 | Thanked: 1 time | Joined on Jan 2006
#3
Originally Posted by DaveC
It stays across reboots in RD mode until you use the flasher utility to reset it back into non-RD mode.

Anyone know exactly the differences of being in RD mode versus the regular mode? Besides making the gainroot command active which is the most obvious change.

Dave

That'd depend on which R&D mode flags you'd set when (re)flashing it. The most obvious effect is that even without any flags set, it changes to the R&D mode image for Stage 1, and posts some data about the various components (Firmware / Kernel / InitFS / RootFS) versions during boot.

I don't recall all of the flags off the top of my head.