My last 10 reboots always finished successfully, and during that time, no new software was installed.

Earlier, I installed HDRcapture and I remember seeing a prompt about Fcam drivers saying that they would only load after the system reboots. A few moments later, I had to take the system down because I needed to change battery (no AC power is available to enable me to perform the hot swap battery trick in case anyone asks). I then realized that the device was in a reboot loop.

Can anyone tell what went wrong? I'll try to see what I can do with it after I make this post by uninstalling packages installed by the hdrcapture install and the package itself using SSH access via USB recovery mode.

By the way, I am using Titan's Kernel Power.